Panasonic PT-VW535N Operating Instructions Manual page 140

Basic format
Transmission from the computer starts with STX, then the ID, command, parameter, and ETX are sent in this order. Add
parameters according to the details of control.
STX A D
(2 byte)
Start (1 byte)
2 ID characters (2 bytes)
Basic format (with sub command)
STX A D
S1 S2 S3
Sub command (5 bytes)
*1 When transmitting a command which does not need a parameter, the operation (E) and parameter are not necessary.
Attention
f If a command is transmitted after the lamp starts illuminating, there may be a delay in response or the command may not be
executed. Try sending or receiving any command after 60 seconds.
f When transmitting multiple commands, be sure to wait until 0.5 seconds has elapsed after receiving the response from the
projector before sending the next command. When transmitting a command which does not need a parameter, a colon (:) is
not necessary.
Note
f If a command cannot be executed, the "ER401" response is sent from the projector to the computer.
f If an invalid parameter is sent, the "ER402" response is sent from the projector to the computer.
f ID transmission in RS-232C supports ZZ (ALL) and 01 to 06.
f If a command is sent with a specified ID, a response will be sent to the computer only in the following cases.
- It matches the projector ID.
- [PROJECTOR ID] is set to [ALL]. (
f STX and ETX are character codes. STX shown in hexadecimal is 02, and ETX shown in hexadecimal is 03.
140 - ENGLISH
Chapter 7 Appendix - Technical Information
ID designate
ZZ, 01 to 06
I1 I2 ; C1
3 command characters (3 bytes)
Semi-colon(1 byte)
Same as basic format
I1 I2 ; C1
S4 S5 E
Operation (1 byte)*
"=" (Value specified using parameter is set)
Æ
page 79)
C2 C3 : P1
Colon(1 byte)
Parameter (undefined length)
C2 C3 :
P1 P2 P3 P4
Parameter (6 bytes)*
1
Symbol "+" or " - " (1 byte) and set value or ad-
justment value (5 bytes)
1
P2 Pn ETX
End (1 byte)
ETX
P5 P6