Table of Contents
Advertisement
IMPORTANT SAFETY INSTRUCTIONS
General air tool warnings
1.
Read and understand this entire manual
before attempting assembly or operation.
2.
Read and understand all warnings posted on
the tool and in this manual. Failure to comply
with all of these warnings may cause serious
injury.
3.
Replace warning labels if they become
obscured or removed.
4.
Do not use this tool for other than its intended
use. If used for other purposes, JET disclaims
any real or implied warranty and holds itself
harmless from any injury that may result from
that use.
5.
Always wear approved safety glasses or face
shield while using this tool. (Everyday
eyeglasses only have impact resistant lenses;
they are not safety glasses.)
6.
Wear ear protectors (plugs or muffs) if the
noise exceeds safe levels.
7.
Wear gloves and protective clothing if
operation produces sparks or flying particles.
Gloves should be tight-fitting, without frayed
fingers or hanging threads. Keep hands and
body away from the working area of tool.
8.
Do not operate an air tool continually at full
throttle without a work load on the tool.
9.
The air tool must be properly lubricated before
operating.
10. Never start a percussion type air tool (chipper,
breaker, buster, etc.) without securing the
tooling in the retainer and placing the tip
against the work surface.
11. Do not operate air tool without its guards in
place. Do not modify the tool.
2
JAT-412 Angled Die Grinder
12. Do not operate this tool while tired or under
13. Adopt a comfortable posture with proper
14. Do not wear loose clothing or jewelry. Confine
15. Excessive air pressure and too much free
16. Check air hoses for wear, and keep them
17. Air hose may cause tripping hazards; keep
18. Do not use this tool near flammable objects,
19. Do not use power tools in damp or wet
20. Do not leave a connected tool unattended.
21. Shut off air supply and discharge any residual
22. Make sure tool is switched off, and your finger
23. Remove adjusting keys and wrenches before
the influence of drugs, alcohol, or any
medication.
balance, and maintain secure footing at all
times. Non-slip footwear or anti-skid floor
strips are recommended.
long hair.
rotation may decrease life of the tool and may
cause a hazardous situation.
away from heat and sharp edges. Repair or
replace damaged air hose immediately. Do
not carry tool by the air hose.
hose away from traffic areas.
or in potentially explosive environments. Do
not use near live electrical wires.
location, or expose them to rain. Keep work
area well lighted.
When not in use, disconnect tool from air
source.
pressure from tool before removing hose,
making adjustments, changing accessories,
or storing tool.
off the trigger, before connecting to air supply.
turning on tool.
Advertisement
Table of Contents
