Sharp AF-W18CME Installation And Operation Manual page 18

INSTALLATION
WARNING:
At this step, make sure the cabinet is
inclined approximately 1cm (3/8") to
the back (Fig.10).
If the cabinet is not properly inclined,
the water collected in the bottom tray
during operation will not drain properly
and may flow into the room where the
air conditioner is installed.
(3)
Attach the bottom gasket to the
gap between the mounting frame
and the unit to seal outside air.
(Fig.9)
6
(1)
Slide the chassis back into the
cabinet. (Fig. 11)
Secure the chassis to the cabinet
(2)
using the screw and angle removed
in Step 2. Push the angle into the
gap between the chassis and the
cabinet. Slide the angle to the right
until the holes meet, and screw it
on to the chassis. (Fig.11)
Replace the front panel. (Fig.12)
(3)
Slide the crank shaft into the
opening of the louver link at the
back of the front panel. (Fig.13)
Remove the grille from the front
(4)
panel. (Fig.14)
Remove the air filter from the front
(5)
panel. (Fig.15)
Secure the front panel with one
short screw(1.2cm/0.5") and
replace the air filter and the grille.
Downloaded from: http://www.usersmanualguide.com/
mounting
frame
Angle
Hole
Fig.12
Front panel
Grille
2
1
Fig.14
Front panel
Air filter
18
cabinet
incline backwards about 1cm
(3/8")
Fig.10
Scratching screw for grounding.
Serration
Chassis
Crank shaft
Front panel
back view
Louver link
Front panel
2
1
Fig.15
Cabinet
Fig.11
Fig.13