Table of Contents
Advertisement
Device setup
Clearing the memory (will remove all linked controllers):
1. Press and hold down both the 'on' and
'o ' buttons until the blue and amber
LEDs flash alternately then release. The
dimmer switch is now in linking mode.
2. On the dimmer switch, press and hold
down the 'o ' button again until the
blue
and
amber
LEDs
flash
simultaneously, then tap (don't hold)
the 'o ' button a further time; the amber
LED will flash to confirm that the
memory has been cleared.
NOTE: Reliable range of remote operation is around 15 metres indoors and
up to 100m outdoors (using a Lightwave Link). This figure may vary
depending upon the environment; very thick walls, bodies of water or large
metal objects may interfere with radio range.
If the distance between the transmitter and receiver is too great to achieve
reliable operation, the LightwaveRF Signal Booster may be used in
conjunction with this product to increase the range.
Advertisement
Table of Contents
