Advanced Setting Functions - Fujitsu P24T-7 LED Operating Manual

Advanced setting functions

Input select
Presence sensor
Proximity
Call Indicator
Overdrive
DDC-CI
Factory recall
Fujitsu
Calling up the Advanced window
Select the input signal
This function is used to select the input signal (VGA, DVI, DP or HDMI).
This is on condition that the display adapter supports this function.
Activating/deactivating the presence sensor
This function shuts down the monitor gradually while you are absent.
After 10 seconds of absence, the brightness is reduced to a minimum.
After 30 seconds with no object present, the display lighting is switched off.
Setting the distance to the monitor
With this function, you can indicate your actual distance to the monitor and
optimise detection by the presence sensor.
The vertical indicator dynamically displays the detected distance to the
monitor. This setting can be used to set the distance within which you want
the sensor to react. If the vertical line is outside the setting bar, this will be
judged as "absent" by the presence sensor.
This setting can only be applied if the Presence Sensor function is active.
Enable/disable Call Indicator
This function shows the status that the user of communication software
(e.g. Microsoft Lync) has, via the LED indicator on the top of the monitor.
Incoming calls are indicated audibly by the communication software using
the monitor speakers.
This function is only available if the communication software supports
transmission of the status.
Activating/deactivating the overdrive function
This function can be used to improve the focus in fast moving images.
This setting can only be configured in Video application mode.
Activating/deactivating the DDC-CI function
DDC-CI (Display Data Channel - Command Interface)
Data can be exchanged through the connection between the PC and the
display.
Activate the factory settings
With this function all settings are reset to the factory settings on
reconfirmation.
The function is executed using
via a VGA data cable. The language selection menu appears.
. The Auto Processing message is displayed
Operation
35