Table of Contents
Advertisement
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the release button
locks into position.
HOW TO SELECT AND START A
PROGRAMME
1. Press the button dedicated to the programme
you want to set.
The light related to the button flashes.
2. Activate Extra Power if desired.
3. Close the appliance door to start the
programme.
HOW TO SELECT AND START THE
PROGRAMME PRE-RINSE
1. To select Pre-rinse, press and hold 30 min for
3 seconds.
The light related to the button flashes.
Extra Power is not applicable to this
programme.
2. Close the appliance door to start the
programme.
HOW TO ACTIVATE EXTRA POWER
1. Select a programme.
2. Press Extra Power.
The light related to the button is on.
Extra Power is not a permanent option
and must be activated every time
before you start a programme.
It is not possible to activate or
deactivate Extra Power while a
programme is running.
Activating Extra Power increases the
water and energy consumption as well
as the programme duration.
HOW TO SELECT AND START THE
PROGRAMME AUTO
1. Press AUTO.
The light related to the button is on.
Extra Power is not applicable to this
programme.
2. Close the appliance door to start the
programme.
The appliance senses the type of load and adjusts
a suitable wash cycle.
HOW TO DELAY THE START OF A
PROGRAMME
You can delay the start of the selected programme
by 3 hours.
1. Select a programme.
2. Press
.
The light related to the button is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible to change
the programme selection.
When the countdown is complete, the programme
starts.
HOW TO CANCEL THE DELAY START WHILE
THE COUNTDOWN OPERATES
Press and hold
for about 3 seconds.
The appliance returns to the programme selection.
If you cancel the delay start, you have
to select the programme again.
HOW TO CANCEL A RUNNING PROGRAMME
Press and hold
for about 3 seconds.
The appliance returns to the programme selection.
Make sure that there is detergent in
the detergent dispenser before you
start a new programme.
OPENING THE DOOR WHILE THE
APPLIANCE OPERATES
Opening the door while a programme is running
stops the appliance. It may affect the energy
consumption and the programme duration. After
closing the door, the appliance continues from the
point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
THE AUTO OFF FUNCTION
This function saves energy by switching the
appliance off when it is not operating.
The function comes into operation automatically:
•
When the programme is completed.
•
After 5 minutes if a programme was not started.
13
Advertisement
Table of Contents
