Table of Contents
Advertisement
Add a RAM Module
The optional Synology RAM module is designed for FlashStation memory expansion. Follow the steps below to
install, check, or remove a RAM module on your FlashStation.
To install a RAM module:
1 Shut down your FlashStation. Disconnect all cables from your FlashStation to prevent any possible damage.
2 Remove the rear top cover.
a Remove the screw on the back of your FlashStation.
b Pull the rear top cover, and put it aside.
Note:
When you remove the rear top cover, you expose sensitive internal components. Avoid touching anything other
than the memory assembly when you remove or add memory.
8 Chapter 2: Hardware Setup
.
Advertisement
Table of Contents
