Table of Contents
Advertisement
For 2.5" Hard Disk: Place the hard disk in the blue area (shown below) of the hard drive tray, turn the tray
upside down, and then tighten the screws to secure the hard disk.
3 Insert the loaded hard drive tray into the empty hard drive bay.
Important:
Make sure the tray is pushed in all the way. Otherwise, the hard disk might not be able to function
properly.
4 Push the hard drive tray handle to secure the hard drive tray.
5 Repeat the steps above to assemble all hard disks you have prepared.
Note:
If you want to set up a RAID set, it is recommended that all installed hard disks are of the same size to make
the best use of hard disk capacity.
Add a RAM Module on RackStation
Synology RAM module 1GB/2GB is designed for RackStation memory expansion, and is optional for your choice.
Follow the steps below to install, check, or remove your RAM module.
Install the RAM Module
1 Shut down your RackStation. Disconnect all cables connected to your RackStation to prevent any possible
damages.
2 Remove the 2 screws on the back of RackStation, and then pull the top cover.
Important:
When you pull out the cover, you expose sensitive internal components. Avoid touching anything other
than the memory assembly when you remove or add memory.
8 Chapter 2: Hardware Setup
Advertisement
Table of Contents
