Table of Contents
Advertisement
Synology FlashStation at a Glance
No.
Article Name
Power Button and
1
Indicator
2
Status Indicator
3
Alert Indicator
4
Beep Off Button
5
Drive Status Indicator
6
Drive Tray
7
Rail Kit Release Tab
8
Power Port
PSU Indicator and Beep
9
Off Button
10
PSU Fan
11
Console Port
PCI Express Expansion
12
Slot
13
SAS OUT Port
14
1GbE LAN Port
15
10GBase-T LAN Port
16
USB 3.0 Port
17
RESET Button
1
For more information about the rail kit installation, please refer to the Quick Installation Guide that comes with the rail kit.
2
The SAS OUT port on the left side is reserved for manufacturing use only. For more information about Synology Expansion Unit supported by your
FlashStation, please visit www.synology.com.
4 Chapter 1: Before You Start
Location
1. Press to power on the FlashStation.
2. To power off the FlashStation, press and hold until you hear a beep
sound and the Power LED starts blinking.
Displays the status of the system. For more information, see "Appendix B:
LED Indicator Table".
Displays warnings regarding fan or temperature. For more information,
see "Appendix B: LED Indicator Table".
Front
Press to deactivate the beeping sound that is emitted when a malfunction
occurs.
Displays the status of drives. For more information, see "Appendix B:
LED Indicator Table".
Install drives (hard disk drives or solid state drives) here.
Push in and hold to release the FlashStation from the rail kit lock.
Connect power cords here..
1. Displays the status of the power supply unit (PSU). For more
information, see "Appendix B: LED Indicator Table".
2. Press to deactivate the beeping sound that is emitted when a
malfunction occurs.
Disposes of excess heat and cools the PSU.
This port is reserved for manufacturing use only.
Supports one PCIe x8 add-on network interface card.
Connect Synology Expansion Unit to the SAS OUT port on the right
Back
side.
2
Connect RJ-45 network cables here.
Connect RJ-45 network cables here.
Connect external drives, USB printers, or other USB devices to the
FlashStation here.
1. Press and hold until you hear a beep sound to restore the default IP
address, DNS server, and password for the admin account.
2. Press and hold until you hear a beep sound, then press and hold
again until you hear three beep sounds to return the FlashStation
to "Not Installed" status so that DiskStation Manager (DSM) can be
reinstalled.
Description
1
Advertisement
Table of Contents
