Synology FlashStation FS2017 Hardware Installation Manual page 10

4 Put back the rear top cover you lifted in step 2.
a Align the hexagons on the sides of the rear top cover with the slots on the chassis' edge, and push the rear
top cover back in position.
b Put back and fasten the screw you removed in step 2-a.
To make sure FlashStation recognizes the new memory capacity:
1 Log in to DSM as admin or a user belonging to the administrators group.
2 Check Total Physical Memory
If your FlashStation does not recognize the memory or fails to start up, check if the RAM module has been
installed properly.
To remove a RAM module:
1 Follow steps 1 to 2 in "To install a RAM module" to shut down your FlashStation, disconnect the cables, and
then remove the rear top cover.
2 Disengage the memory retaining clips by pushing them outwards, and the module will pop out of the slot.
3 Follow step 4 in "To install a RAM module" to put back the rear top cover.
10 Chapter 2: Hardware Setup
in Control Panel > Info Center.