Table of Contents
Advertisement
Start Up Your RackStation
1 Connect one end of the power cord to the power port of RackStation, and the other to the power outlet.
2 Use the LAN cable to connect RackStation to your switch/router/hub.
3 Press and hold the power button to turn on your RackStation.
Your RackStation is now online and detectable from a network computer.
Add a RAM Module on RackStation
Synology RAM module 2GB is designed for RackStation memory expansion, and is optional for your choice.
Follow the steps below to install, check, or remove your RAM module.
Install the RAM Module
1 Shut down your RackStation. Disconnect all cables connected to your RackStation to prevent any possible
damages.
2 Unscrew the two knobs that secure the back panel. Pull out the panel to reveal the circuit board.
Important:
When you pull out the panel, you expose sensitive internal components. Avoid touching anything other
than the memory assembly when you remove or add memory.
8 Chapter 2: Hardware Setup
Hide quick links:
Advertisement
Table of Contents
