Table of Contents
Advertisement
2) Replace batteries
Problem: No outdoor temperature is displayed.
Solution: 1) Remove all batteries, reinsert into sender first, then display.
2) Place remote sender closer to display.
3) Be sure all batteries are fresh.
4) Place Remote Control Sender and Weather Station in position so the straight-line
signal is not passing through more than two or three walls.
Problem: Temperatures do not match if units are placed next to each other.
Solution: Each temperature sensor is manufactured to be accurate to within 2ºF plus or minus
and under normal conditions, so two sensors could be as much as 4ºF different.
However, the difference can be exaggerated further because the sensors are
designed for different working environments. The indoor sensor is less responsive to
ambient air currents because of the shielding effect of the display's case. In addition,
the case can act as a heat sink to absorb and store heat from external sources (i.e.
handling of the case or radiant heat). Also, the much greater range of the outdoor
temperature sensor requires a different calibration curve than the indoor range. Error
is usually greater at the extreme ends of a range, making it harder to compare
different ranges with different curves. Under non-laboratory conditions, it is difficult to
compensate for the above factors and obtain an accurate comparison.
MAINTENANCE AND CARE INSTRUCTIONS
•
Extreme temperatures, vibration, and shock should be avoided to prevent
damage to the units.
•
Clean displays and units with a soft, damp cloth. Do not use solvents or scouring
agents; they may mark the displays and casings.
•
Do not submerge in water.
•
Immediately remove all low powered batteries to avoid leakage and damage.
•
Opening the casings invalidates the warranty. Do not try to repair the unit.
Contact La Crosse Technology for repairs.
SPECIFICATIONS
Temperature measuring range:
Indoor:
Outdoor:
Indoor relative humidity measuring
range:
Indoor Temperature checking interval:
Indoor Humidity checking interval:
Outdoor Temperature checking interval
(Remote Temperature Sensor):
Outdoor Temperature reception
(Weather Station):
14.1°F to 139.8°F with 0.2°F resolution.
(-9.9°C to 59.8°C with 0.1°C resolution)
displayed if outside this range.
-39.8 °F to 139.8°F with 0.2°F resolution.
(-39.8°C to 59.8°C with 0.1°C resolution).
displayed if outside this range.
1% to 99% with 1% resolution.
temperature is OL.F; display "- -" if < 1% and "99%"
if > 99%)
Every 10 seconds.
Every
15 seconds.
Every
4 seconds
Every 4 seconds.
17
"OFL"
"OFL"
(
Display "- -" if
Advertisement
Table of Contents
