Table of Contents
Advertisement
Other Information
Changing the Digital
Home Receiver's RF
Output Channel
12
If you connected the Digital Home Receiver to your TV or VCR using
an RF connection (as described on pages 9 and 10), you need to set
the RF output channel of the Digital Home Receiver to match the RF
channel (channel 3 or 4) of the cable service provided in your area.
The Digital Home Receiver is shipped with its RF output channel set
to channel 3.
To set the RF output channel of the Digital Home Receiver
1
Using the buttons on the front panel, first press the
button to turn off the Digital Home Receiver, which puts the unit
in standby mode.
2
To set the Digital Home Receiver to channel 3 or 4:
To Use RF
Press These Front Panel Buttons Sequentially
Channel 3
F
Channel 4
F
3
Do one of the following:
❑
If you connected the Digital Home Receiver to your TV (as
described on page 9), tune your TV to channel 3 to see cable
channels.
❑
If you connected the Digital Home Receiver to your VCR (as
described on page 10), set your VCR's RF channel switch
(usually on the rear panel) to channel 3 to see cable channels.
(cursor up),
(cursor right),
g
(cursor up),
(cursor right),
g
STANDBY 1
(cursor down)
f
(cursor up)
F
Advertisement
Table of Contents
