Sony CABLEVISION DHG-B45CV Hardware Setup Instructions page 3

Digital home receiver
Table of Contents

Advertisement

WARNING
To reduce the risk of fire or shock hazard, do not expose the unit to
rain or moisture.
CAUTION
RISK OF ELECTRIC SHOCK
ATTENTION
RISQUE DE CHOC ELECTRIQUE,
PRECAUCION
RIESGO DE CHOQUE ELECTRICO
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol is intended to alert the user to the
presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert the user to the
presence of important operating and maintenance
(servicing) instructions in the literature
accompanying the appliance.
CAUTION
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
Note on Cleaning the Unit
Clean the unit with a soft dry cloth. Never use strong solvents such
as thinner or benzine, which might damage the finish of the
cabinet.
Note to CATV System Installer
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides guidelines for
proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as close
to the point of cable entry as practical.
Use of this television receiver for other than private viewing of
programs broadcast on UHF or VHF or transmitted by cable
companies for the use of the general public may require
authorization from the broadcaster/cable company and/or
program owner.
Trademark, Copyright, and License Information
All rights reserved. Reproduction in whole or in part without
written permission is prohibited. Sony, Digital Home Receiver, and
the Sony logo are trademarks of Sony. CABLEVISION and the
CABLEVISION logo are registered trademarks of CABLEVISION
SYSTEMS CORPORATION. Macrovision is a trademark of
Macrovision Corporation.
DO NOT OPEN
NE PAS OUVRIR
NO ABRIR
Macrovision
This product incorporates copyright protection technology that is
protected by U.S. patents and other intellectual property rights.
Use of this copyright protection technology must be authorized by
Macrovision, and is intended for home and other limited pay-per-
view uses only unless otherwise authorized by Macrovision.
Reverse engineering or disassembly is prohibited.
Features May Change
The features described in this manual may change due to
unscheduled automatic software upgrades activated by the service
provider without prior notice.
Customer Service
If you have any problems with this unit, please contact
the following:
CABLEVISION SYSTEMS CORPORATION
CUSTOMER SERVICE
TEL: (516) 802-DSTB (3782)
Regulatory Information
Declaration of Conformity
Trade Name:
SONY
Model No.:
DHG-B45CV
Responsible Party:
Sony Electronics Inc.
Address:
1 Sony Drive
Park Ridge, NJ 07656
Telephone No:
201-930-6972
This device complies with Part 15 of the FCC rules.
Operation is subject to the two following conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTIFICATION
This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference with radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Ensure that the RF input connector is securely attached.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Safety Instruction for Pluggable Equipment
The socket-outlet shall be installed near the equipment and shall be
easily accessible.
Safety
Operate the unit only on AC 60 Hz 110-120 V.
The plug is designed, for safety purposes, to fit into the wall
outlet only one way.
If any liquid or solid object should fall inside the cabinet,
unplug the unit immediately and have it checked by
qualified service personnel before operating it further.

Advertisement

Table of Contents
loading

Table of Contents