State Water Heaters 310C Installation Manual And Owner's Manual page 35

You can get some information about the water heater condition by pressing the "INFO" button. For
more information, follow the procedures below:
INFO
Button
Inlet water temperature will be displayed on
1st. press
the remote controller by pressing the "INFO"
button.
Outlet water temperature will be displayed on
2nd. press
the remote controller by pressing the "INFO"
button.
Water flow will be displayed on the remote
3rd. press
controller by pressing the "INFO" button.
Press the "INFO" button to finish information
4th. press
mode.
The controller has a function that can change units of temperature and flow rate from °F to °C and from
gallon per minute to liter per minute and vice versa, please follow the procedures below:
Press the "ON/OFF" button on the controller in
1.
order to turn the controller on.
2.
When ON, the orange LED is lit.
The previous set temperature will be displayed on
3.
the screen.
4.
Press the "INFO" buttons for at least 3 seconds.
The set temperature should now be displayed in the
5.
alternate unit of measurement.
ADDITIONAL FEATURES
-Information mode-
Operation
-Unit conversion mode-
Operation
35
Sold by www.GadgetsGo.com Authorized Dealer
Screen on the controller
Built-in controller
Inlet water
temperature
Outlet water
temperature
Water flow
Screen on the controller
Built-in controller
Page
Owner's Guide
Normal Operation
Remote controller
Remote controller
(EX.: 100 °F)
(EX.: 38 °C)