Temperature Remote Controller - State Water Heaters 310C Installation Manual And Owner's Manual

TEMPERATURE REMOTE CONTROLLER

Verify that the items listed below are included with the remote controller.
Temperature
remote controller*
9009069005 (TM-RE42)
*
This remote controller is NOT waterproof.
The water heater can only have one remote controller.
Do not install in high temperature environments, high humidity conditions out-
doors, in direct sunlight, or within the reach of children.
CAUTION
Make sure the remote controller does not come into contact with water or oil.
• Do not place the remote control wiring close to other wires from other
• Do not extend the remote control wiring more than 400 ft. (122 m.)
<Mounting and wiring the remote controller>
1. Take off the "Back plate" from the remote controller with a flat head screwdriver. (Fig. A and B)
2. Attach the "Back plate" on the wall with the two provided screws. (Fig. B)
Fig. A
Twist
-Optional item-
Qty: 1
-INSTALLATION-
products.
Press and twist flat head
screwdriver against the cutout.
Main body
Fig. B
Attach the screws
Main body
22
Sold by www.GadgetsGo.com Authorized Dealer
Screws
Qty: 2
Back plate
Cut out the partition with pliers
Page
Installation Manual
Installation
Manual
Qty: 1
3-1/4 inches
(82.6 mm)