State Water Heaters 310C Installation Manual And Owner's Manual page 23

3. Crimp the "Fork terminals" to the cable. (Fig. C)
4. Tighten the two "Fork terminals" beneath the two
"Remote controller terminal" screws on the back of
the main body. (Fig. D-1)
5. Cut out the inlet for the remote controller cable
from the bottom of the main body. (Fig. D-2)
6. Place the "Main body" back on the "Back plate",
with the "Remote controller cable" running out of
the bottom inlet.
Fig. D-2
Inlet for the remote
controller cable
<How to connect the remote controller to the water heater>
1. Disconnect power supply from the water heater.
2. Take off the water heater's front cover.
3. Locate the two terminals for the remote controller in the water heater. (Refer to the Fig. E-1 and E-2.)
4. Put the remote controller cable through the hole at the bottom of the casing of water heater from
outside.
5. Properly connect the two terminals attached to the end of the remote control wires to the terminals
for the remote controller on or near the computer board with the screws. (No polarity)
* Do NOT jump or short-circuit the wires, or the computer will be damaged.
6. Replace the water heater's front cover securely.
Wires used for the remote controller connection must be:
Fig. E-1
110C and
310C models
Connect other end to these terminals
Cut out
• Minimum 20 gauge wire (No polarity)
• Maximum 400 ft. (122 m) long
9009069005
(TM-RE42)
23
Sold by www.GadgetsGo.com Authorized Dealer
Fig. C
Remote controller cable
Fig. D-1
Remote controller
terminals
Remote controller cable
Fig. E-2
510C model
Connect other end to these terminals
Page
Installation Manual
Installation
1-3/8 Inch
(35 mm)
Fork
Terminals
1-5/8 Inch
(41 mm)
Two fork terminals
9009069005
(TM-RE42)