Using The Device; Handling Electrical Cables - Dometic CoolAir SPX1200T Installation Manual

SPX1200T
2.1

Using the device

• Only use the parking cooler for the purpose specified by the manufacturer
and do not make any alterations or structural changes to the device.
• Do not use the parking cooler if it is visibly damaged.
• The parking cooler must be installed safely so that it cannot tip over or fall
down.
• Installation, maintenance and repair work may only be carried out by
qualified personnel from a specialist company who are familiar with the risks
involved and the relevant regulations.
• Do not use the parking cooler near flammable fluids and gases.
• Do not operate the parking cooler if the ambient temperature is below 0 °C.
• Do not undo the upper cover of the parking cooler in the event of a fire. Use
approved extinguishing agents instead. Do not use water to extinguish fires.
• Please inform your vehicle manufacturer if the height entered in your vehicle
documents needs to be altered due to the installation of the parking cooler.
– SPX1200T height: 53 mm
• Disconnect all power supply lines when working on the parking cooler
(cleaning, maintenance, etc).
2.2

Handling electrical cables

• Use cable ducts to lay cables through walls with sharp edges.
• Do not lay loose or bent cables next to electrically conductive materials
(metal).
• Do not pull on the cables.
• Attach and lay the cables in such a manner that they cannot be tripped over
or damaged.
• The electrical power supply may only be connected by a specialist work-
shop.
• The connection to the vehicle's electrical system should be protected as
follows:
– power supply: 40 A
– voltage monitor: 2 A
• Never lay power supply lines (battery leads) in the vicinity of signal or control
cables.
EN
Safety instructions
5