Table of Contents
Advertisement
Leak Testing
Although all gas connections on the grill are leak
tested at the factory prior to shipment, a
complete gas tightness check must be performed
at the installation due to possible mishandling in
shipment or excessive pressure unknowingly
being applied to the unit. Periodically check the
whole system for leaks, or immediately check if
the smell of gas is detected.
• Do not smoke while leak testing.
• Extinguish all flames.
• Never leak test with an open flame
1
Make a soap solution of one part liquid detergent and
one part water. You will need a spray bottle, brush or
towel to apply the solution to the fittings.
Note: For LP/Propane units, check with a full cylinder.
3
Apply the soap solution to fittings.
CAUTION
Before placing into operation, always check for
gas leaks with a soapy water solution. DO NOT
USE AN OPEN FLAME TO CHECK FOR LEAKS.
2
Check that all control knobs are in the "OFF" position.
4
Turn cylinder valve knob counter clockwise one
turn to open.
22
Advertisement
Table of Contents
