Table of Contents
Advertisement
[PIN code change]
Change the PIN code.
1)
Press as to select [Security].
2)
Press the <ENTER> button.
f The [Security] screen is displayed.
3)
Press as to select [PIN code change].
4)
Press the <ENTER> button.
f The [PIN code] input screen is displayed.
5)
Enter the PIN code you have set according to the steps in "Enter a PIN code" (x page 67).
6)
Press the <ENTER> button.
f The [New PIN code] input screen is displayed.
7)
Enter the New PIN code according to the steps in "Enter a PIN code".
[Power management]
Switch the projector to standby state or ready state when the no-signal status continues. You can select the standby state or
ready state, the waiting time it takes for the power management function to work, as well as the waiting time before switching
from the ready state to the standby state.
1)
Press as to select [Power management].
2)
Press the <ENTER> button.
f The [Power management] screen is displayed.
3)
Press as to select [Ready], [Shut down] or [Off].
When there is no signal input for 30 seconds, the countdown timer is displayed. When the time set in
[Timer] has elapsed, the luminous lamp turns off and the projector enters the Ready state after cooling.
If a signal is input in Ready mode, or when you press any button other than the power <v/b> button,
the luminous lamp turns on and the projector enters the projection state. Pressing the power <v/b>
[Ready]
button during the Ready state will enter the standby state.
In addition, when the time set in [Ready countdown] has elapsed, the projector will switch from the
Ready state to the standby state.
When there is no signal input for 30 seconds, the countdown timer is displayed. When the time set
[Shut down]
in [Timer] has elapsed, the luminous lamp turns off and the projector enters the standby state after
cooling.
[Off]
Disables the power management function.
4)
Press the <ENTER> button.
f A check mark is displayed on the left of the item selected in Step 3).
f Proceed to Step 5) when [Ready] or [Shut down] is selected.
5)
Press as to select [Timer].
6)
Press the <ENTER> button.
7)
Press as to switch the setting time of [Timer].
f The setting time will switch each time you press the button.
f The time until the power management function works can be set to any value from 1 minute to 30 minutes in increments
of 1 minute.
f Proceed to Step 8) when [Ready] is selected in Step 3).
8)
Press the <MENU> button.
9)
Press as to select [Ready Countdown].
10) Press the <ENTER> button.
68 - ENGLISH
Chapter 4 Settings - [Expand] menu
Advertisement
Table of Contents
