Table of Contents
Advertisement
Note
f The remote control can be used within a distance of about 5 m (16'4-13/16") if pointed directly at the remote control signal
receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control
range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not
operate correctly.
f You can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to
the loss of light caused by the properties of the screen.
f When the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become
inoperative. Set the projector as far from the luminous source as possible.
Projector body
Front
1
2
Rear
AC IN
5
6
Projection direction
WARNING
Keep your hands and other objects away from the air exhaust port.
f Keep your hand and face away.
f Do not insert your finger.
f Keep heat-sensitive articles away.
Heated air from the air exhaust port can cause burns, injury, or deformations.
1 Adjustable feet
Adjust the projection angle.
2 Projection Lens
3 Remote control signal receiver (front)
4 Air exhaust port
5 <AC IN> terminal
Connect the supplied power cord.
6 Security slot
This security slot is compatible with the Kensington
security cables.
Attention
f Do not block the ventilation ports (intake and exhaust) of the projector.
22 - ENGLISH
Chapter 1 Preparation - About your projector
3
1
7
8
9
10
Side
1
Side
11
7 Remote control signal receiver (rear)
8 Security chain hook
Attaches a burglar prevention cable, etc.
9 Rear terminals
10 Speaker
11 Air intake port / Air filter cover (x page 93)
The air filter unit is inside.
4
1
Advertisement
Table of Contents
