Table of Contents
Advertisement
Items
Press the w button.
Press the q button.
[Curved
correction X
Offset]
Press the a button.
Press the s button.
Press the w button.
Press the q button.
[Curved
correction Y
Offset]
Press the a button.
Press the s button.
Note
f Either [H/V Keystone] or [Corner correction] setting value is valid. If the other item is adjusted after [H/V Keystone] or [Corner
correction] was adjusted, the previous setting value will be reset.
f The [Curved correction X Offset] and the [Curved correction Y Offset] cannot be adjusted independently. After adjusting the
[Curved correction X/Y Gain] at the beginning, please adjust the [Curved correction X Offset] and the [Curved correction Y
Offset].
f Press the <KEYSTONE> button on the control panel or on the remote control when the [H/V Keystone], [Corner
correction] or [Curved correction] individual adjustment screen is displaying, the individual adjustment screen will switch
as follows.
- [H/V Keystone] [Corner correction] (Upper left) [Corner correction] (Upper right) [Corner correction] (Lower right)
[Corner correction] (Lower left) [Curved correction X/Y Gain] [Curved correction X Offset] [Curved correction Y
Offset] [H/V Keystone] ...
f Correcting up to ±15° for the tilt in the vertical direction and ±15° for the tilt in the horizontal direction are available for
adjustments with [Keystone]. However, the image quality will degrade and it will get harder to focus with more correction.
Install the projector so that the correction will be as small as possible.
f Screen size will also change when [H/V Keystone] is used to perform various adjustments.
f Aspect ratio of the image size may shift depending on the correction.
Resetting the correction state of [Keystone]
Cancel the state corrected with the screen adjustment function, and return to factory default.
1)
Press as to select [Keystone].
2)
Press the <ENTER> button.
f The [Keystone] screen is displayed.
3)
Press as to select [Reset value].
4)
Press the <ENTER> button.
f The state of the keystone correction is canceled.
[Logo]
Set logo selection, user logo registration and logo operation security.
1)
Press as to select [Logo].
64 - ENGLISH
Chapter 4 Settings - [Expand] menu
Operation
Used to correct the right side vertical
lines. Extend the top and bottom while
keeping the center part as it is.
Used to correct the left side vertical
lines. Extend the top and bottom while
keeping the center part as it is.
Used to correct the both sides of the
vertical lines. Extend the lower corners
while keeping the center part and the
upper part as they are.
Used to correct the both sides of the
vertical lines. Extend the top corners
while keeping the center part and the
lower part as they are.
Used to correct the right side
horizontal lines. Extend the top and
bottom while keeping the center part
as it is.
Used to correct the left side horizontal
lines. Extend the top and bottom while
keeping the center part as it is.
Used to correct the both sides of the
horizontal lines. Extend the lower
corners while keeping the center part
and the upper part as they are.
Used to correct the both sides of the
horizontal lines. Extend the top corners
while keeping the center part and the
lower part as they are.
Adjustment
Advertisement
Table of Contents
