1.5
Microscope introduction:
1.5.1
IR Remote Area/Indicator
When both ○
standby mode.
Caution: Please remove the transparent protection sheet on the
IR receiver area.
(1)
IR remote control aiming area○
whenever buttons are pressed. If the indicator did not blink
means the signal was not delivered and please repress again
(2)
HDMI indicator○
mode. If light blinks, means microscope does not connect with
monitor.
(3)
PCCam Indicator○
and ○
LED indicator blinks, the microscope is in
g
h
When lit up, the microscope is in HDMI
:
g
: When lit up, the device is in USB mode.
h
○
○
g
The indicator will blink
f
:
23
○
f
h
.