Advertisement
Quick Links
Advertisement
Related Manuals for APART SDQ5PIR-BL
Summary of Contents for APART SDQ5PIR-BL
- Page 1 MANUAL SDQ5Pir INFO@APART-AUDIO.COM...
- Page 2 Features The APart SDQ5Pir powered loudspeaker set is a versatile and very compact, easy to use, plug and play sound system. It consists of an amplified loudspeaker with a 5.25” woofer, a high frequency unit and a second linkable passive loudspeaker, powered by the second amplifier built into the active speaker. The speakers are magnetically shielded.
-
Page 3: Rear Panel
In this case, the left input signal only is used on both channels. 12. Input A minijack: standard 3.2 mm stereo minijack connector for input A. 13. RS232 connector: standard SUB D9 connector for serial control. 14. Heatsink. INFO@APART-AUDIO.COM... - Page 4 EQBASS sets the level of the bass. EQTREB sets the level of the treble. The value must be between -14 and 14 in steps of 2. If a different value is used (e.g. “5”), it will be changed to the closest match. WWW.APART-AUDIO.COM...
- Page 5 AUTOPW time has elapsed. When set to 0, the AUTOPW function in not active. Values between 0 and 30 can be specified. 0 = inactive, 1 = auto power off after 1 minute etc...Default value is 15 minutes. INFO@APART-AUDIO.COM...
- Page 6 (green led at the back is lit) and resend the instruction. When the SDQ5Pir is in standby mode, the AUPTRG function will not be able to wake up the speaker. In standby mode, the SDQ5Pir can only be activated by a SET STANDBY OFF command. WWW.APART-AUDIO.COM...
- Page 7 GET, SET ON or OFF control AUTOPW Auto power off GET, SET 0 to 30 0 (OFF) AUPTRG Auto power GET, SET 0 to 9 trigger level INFO settings information HWVRSN Hardware version SWVRSN Software version RESTORE Restore factory defaults INFO@APART-AUDIO.COM...
-
Page 8: Ir Remote Control
This will avoid possible damage or corrosion from battery leakage. Warning: Do not attempt to recharge, disassemble, or incinerate this type of battery. Keep all batteries away from children. Dispose of used batteries promptly and as regulated by applicable laws. WWW.APART-AUDIO.COM... - Page 9 Power STANDBY Input A Input B Input A + B Input WALL Level UP Level Down MUTE Bass UP Bass DOWN SDQ5Pir device code is “807F” Treble UP Infrared commands have been coded according to the NEC® protocol Treble Down INFO@APART-AUDIO.COM...
-
Page 10: Technical Specifications
270 x 210 x 440 accessories supplied Power cord, bracket, manual, infrared remote control unit, connection wire Remote control unit battery type lithium CR2025 3v operating temperature -10 to +40° C relative humidity 10 to 90% non condensing WWW.APART-AUDIO.COM... -
Page 11: Important Safety Instructions
Do not remove the cover. Removing the cover will expose you to potentially dangerous voltages. • Do not drive the inputs with a signal level higher than that required to drive equipment to full output. • In case of mal-function this device should be serviced by qualified service personnel only. INFO@APART-AUDIO.COM... - Page 12 Company names, product names, and names of formats etc. are the trademarks or registered trademarks of their respective owners. © 2009 APart-Audio specifications subject to change without notice. WWW.APART-AUDIO.COM...
Need help?
Do you have a question about the SDQ5PIR-BL and is the answer not in the manual?
Questions and answers
APart SDQ5PIR все диоды горят (на головном динамике зеленый, на панели управления синим), уровень звука в среднем положении, но звука нет