Table of Contents
Advertisement
the device must be take out of operation, disconnected and then be cleaned with a dry cloth. Dust can
reduce the insulation which may lead to mortal electrical shock. More severe dirt in and at the device
should only be removed by a specialist.
There must never enter any liquid into power outlets, extension cords or any holes in the housing of the
device. If you suppose that also a minimal amount of liquid may have exerted the device it must
immediately be disconnected. This is also valid, if the device was exposed to high humidity. Also if the
device is still running, the device must be checking by a specialist if the liquid has reduced any
insulation. Reduced insulation can cause mortal electrical shock. There must never be any objects
entering into the device. This is especially valid for metal parts. If any metal parts like staples or coarse
metal chips enter into the device, the device must be taken out of operation and disconnected
immediately. Malfunction or short-circuits caused by metal parts may cause mortal injuries. Never look
directly into the light source, as sensitive persons may suffer an epileptic shock (especially meant for
epileptics). Keep away children and amateurs. Never leave this device running unattended.
OPERATING DETERMINATIONS
This device is designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects. Do not shake the device. Avoid brute force when
installing or operation the device. Never lift the fixture by holding it at the projector-head. As the
mechanics may be damaged. When choosing the installation-spot, please make sure that the device is
not exposed to extreme heat, moisture or dust. There should not be any cable lying around. Please
make sure that the fixture can not be touched or bumped. Your endanger your own and the safety of
others.
This device must never be operated or stockpiled in surroundings' where splash water, rain, moisture
or fog may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal
electrical shocks. When using smoking machines, make sure that the device is never exposed to the
direct smoke jet and is installed in a distance of 0.5 meters between smoke machine and device. The
room must only be saturated with an amount of smoke that the visibility will always be more then 10
meters.
The housing must never touch surrounding surfaces or objects. Make sure that the area below the
installation place is blocked when rigging, dragging or servicing the fixture. For overhead use
(mounting height >100cm), always fix the fixture with an appropriate safety-rope. Fix the safety-rope at
the correct fixation points only. The safety-rope must never be fixed at the transport handles. Only
operate the fixture after having check that the housing is firmly closed and all screws are tightly fastened.
The maximum ambient temperature Ta = 40°C must never be exceeded. Operate the device only after
having become familiarized with its functions. Do not permit operation by persons not qualified for
operating the device. Most damages are the result of unprofessional operation. Please use the original
packaging if the device is to be transported. Please consider that unauthorized modifications on the
device are forbidden due to safety reasons! Never remove the serial barcode from the device as this
would make the guarantee void. If this device will be operated in any way different to the one described
in this manual, the product may suffer damages and the guarantee becomes void. Furthermore, any
other operation may lead to dangers like short-circuit, burns, electric shock, crash etc.
3
Advertisement
Table of Contents
