Table of Contents
Advertisement
DESCRIPTION OF THE DEVICE
Features
> 150W RGB COB LED
> 12/5/4/3 channels in option
> Variable electronic dimmer (0-100%) and electronic strobe
> LED operation menu with function buttons
> Electronic zoom
> Build-in program with speed adjustment
> 16 bit dimmer effect and White balance
> Temperature sensor via software to control fans speed against overheat
> 5 different DMX channel modes. Including STAG, ARC, AR1D, AR1S and HSV
INSTALLATION
Rigging
The installation of the projector has to be built and constructed in a way that it can hold 10 times
the weight for 1 hour without any harming deformation.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including
calculating working load limits, installation material being used, and periodic safety inspection of
all installation material and the projector. If you lack these qualifications, do not attempt the
installation yourself, but instead use a professional structural rigger. Improper installation can
result in bodily injury and or damage to property. The projector had to be installed out of the reach
of people.
DANGER OF FIRE! When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5m.
DMX 512 connection/ connection between fixture
The wires must not come into contact with each other, otherwise the fixture will not work at all or
properly. Please note the starting address depends upon which controller is being used. Only use a
DMX cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or
one fixture to another.
4
Advertisement
Table of Contents
