Advertisement
ELECTRIC CABINET BASE CONVECTION STEAMER, MODELS ECX-2, ECX-10
3.0 OPERATING INSTRUCTIONS
BOILER SECTION
Electrically powered steam generators are available with standard boiler controls or ASME
CSD-1 compliant controls. In addition to the ON/OFF power switch and indicator pilot light or
the standard controls, the CSD-1 controls have in addition four more indicator pilot lights and a
"Reset" switch. Follow the appropriate instructions for each.
Start-up Procedure, Standard Controls
1. Turn on water and power supply to appliance.
2. Close the manual blowdown valve if the units is not equipped with the optional automatic
blowdown valve.
3. Open door of cabinet and turn on Power Switch. Pilot light will come ON and water will
begin to enter boiler. Once water level has reached the proper operating level as indicated
on water gauge glass the heating elements will be energized and heat the water. When
steam pressure has reached 11 psi the elements will de-energize and cycle on and off
between 9 - 11 psi. The boiler is now ready for steam generation.
Start-up Procedure, CSD-1 Controls
1. Turn on water and power supply to appliance.
2. Close the manual blowdown valve if the units is not equipped with the optional automatic
blowdown valve.
3. Open cabinet door and turn "ON" power switch.
The green pilot light will come "ON." Water will begin to enter the boiler. When enough
water has entered the boiler the (red) "Low Water" pilot will come on for approximately 10
seconds and then the (amber)"Standby" pilot light will come.
4. Press the "Reset" switch to begin boiler operation.
The "Standby" pilot light will go off and the boiler will begin operation. When steam
pressure has reached 11 psi the elements will de-energize and cycle on and off between 9 -
11 psi. The boiler is now ready for steam generation.
PART NUMBER 10058R2
INSTALLATION AND OPERATION MANUAL,
6
2008-11-12
Advertisement
