Sharp XL-DV484W Operation Manual page 64

XL-DV484W
Recording to a cassette tape (continued)
XL-DV555W
ENGLISH
Recording from several CDs continuously:
1. Perform steps 1 - 6 in "Recording from a CD (CDs)" on page 60.
2. Within 5 seconds, press the 0 button to record on side A, or the 1 button
for side B.
To perform programmed recording:
1. Programme discs and tracks. (See page 49.)
2. Press the I6 button.
3. Press the 0 button to record on side A, or the 1 button for side B.
To stop recording:
Press the H button.
The CD and tape will stop.
Note:
To record on both sides, begin with side A. (If recording is started from side B,
the tape will not switch over to side A.)
Auto restart function:
If the recording side is switched from side A to B during recording, the system
will record the interrupted track on side B from its beginning. The recording will
be made without cutting the beginning of the track on side B.
E-61
*DV484W_EP57-61 61
Recording from the radio
H
1
Tune in to the desired station. (See page 54.)
2
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one side.
4
Press the I6 button.
Recording will be paused.
5
Press the 0 button to record on side A, or the 1 button
for side B.
To record on both sides, begin with side A. (If recording is started from
side B, the tape will not switch over to side A.)
To interrupt recording:
Press the I6 button.
To resume recording, press the same recording button you pressed in step 5.
Other buttons do not allow resuming.
To stop recording:
Press the H button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop
aerial.
Erasing recorded tapes
H
1. Press the TAPE button.
2. Follow steps 2-5 in "Recording from the radio".
04.2.20, 17:27
XL-DV484W(Z)
TINSZA032AWZZ