LG PQNUD1S41 Installation & Owner's Manual page 38

SETTING AND USING METHOD
38
• Checking accumulative power
Accumulative power: After the power is initially connected to the power indicator, the values
are accumulated.
If the displayed electric energy is 999 999 or above, it will return to 0.
• Screen Description
A D D R - 0 :
A D D R - 1 :
A D D R - 2 :
- Press the LEFT/RIGHT (◀,▶)button to increase/decrease the wattmeter number.
- Press the UP/DOWN (s,t)button to check the electric energy of all indoor units connected.
- In 1.15 or less version, each indoor unit number increases sequentially according to the set
number of units.
- In 1.16 or higher version, it displays the address of the indoor unit set for each indoor unit num-
ber.
- If the standby power is set to Manual, the last page is displayed as follows.
- In 1.16 or higher version, if you press left/right button(◀, ▶), it is displayed as follows in the last
page.
You can check the entire indoor units' accumulated power for each address in this screen.
A C C U M ( A L L )
A D D R - 0 :
A D D R - 1 :
A D D R - 2 :
CAUTION
!
• According to watt-hour meter and PDI installation time, the final accumulated value dis-
played by each may be different.
• During the ACP/Smart interface, if you set the e-mail, e-mail alarm is sent when wattage
distribution cannot be made by special conditions.
• PDI accumulated power value is not initialized.
• When you change the indoor unit address, you can check the accumulated power amount
of each indoor unit address that is not set to each port in ACCUM(ALL) screen.
Wattmeter number
Overall accumulated power
of P(1) wattmeter
Accumulated power of each
applicable indoor unit
Each indoor unit number
0 . 0 k W h
0 . 0 k W h
0 . 0 k W h