LG PQNUD1S41 Installation & Owner's Manual page 24

SETTING AND USING METHOD
24
Setting functions (EHP products)
• Connection type setting: Setting based on system configuration
- In case of power indicator single composition: MASTER
- In case of central controller interface: SLAVE
※In 1.16 or higher version, SLAVE-RC setting is possible, and in case of central controller in-
terface, if one unit of SLAVE is set as SLAVE-RC, protection logic for distribution error by
central controller failure is operated.
C O N N E C T I O N :
W H M T Y P E :
R E M O T E C O M :
S T A N D B Y P :
' When the CONNECTION item flashes, press the SELECT button to enter the setting window.
Press the SELECT button at the item to set to save the setting and return to the initial setting
screen.
CAUTION
!
• When you set the connection type, you need to set only one unit as SLAVE RC Type.
• Wattmeter type setting: Setting based on connected wattmeter.
- Pulse: When using wattmeter that sends electric energy as pulse signal
- RS-485: When using wattmeter that sends electric energy via RS-485 communication
C O N N E C T I O N :
W H M T Y P E :
R E M O T E C O M :
S T A N D B Y P :
' When the WHM TYPE item flashes, press the SELECT button to enter the setting window.
Press the SELECT button at the item to set to save the setting and return to the initial setting
screen.
• Whether to use remote reading and set the reading company
- NOT USE: Not use the remote reading function
- Set the remote reading company to use
C O N N E C T I O N :
W H M T Y P E :
R E M O T E C O M :
S T A N D B Y P :
M A S T E R
P U L S E
N O T U S E
A U T O
M A S T E R
P U L S E
N O T U S E
A U T O
M A S T E R
P U L S E
N O T U S E
A U T O
C O N N E C T I O N
T Y P E
1 .
M A S T E R
2 . S L A V E
3 .
S L A V E - R C
W H M T Y P E S E
L E C T I O N
1 .
P U L S E
2 .
R S - 4 8 5
R E M O T E R E A D I N G
1 . N O T U S E
2 . M I C R O N I C
3 . L S I S
R E M O T E R E A D
I N G
4 .
L G A C P
C O M .
M .
C O