Dacor Heritage Pro HDPR48S Installation Instructions Manual
Hide thumbs
Also See for Heritage Pro HDPR48S:
- User manual (48 pages) ,
- Installation instructions and owner's manual (36 pages) ,
- User manual (48 pages)
Related Manuals for Dacor Heritage Pro HDPR48S
Summary of Contents for Dacor Heritage Pro HDPR48S
- Page 1 Installation Instructions Heritage Pro Range HDPR30S, HDPR36S, HDPR48S, HDER30S, HDER36S, HDER48S Part No. 113428 Rev A...
-
Page 2: Table Of Contents
Table of Contents Before You Begin Important Notes Customer-Assurance Information Important Safety Instructions Safety Symbols and Cautionary Information Installation-Related Safety Instructions Consignes de sécurité importante Instructions de sécurité relatives à l'installation Product Specifications HDPR30S, -36S, -48S Ranges HDER30S, -36S, -48S Ranges Included Accessories: HDPR30S/HDER30S Included Accessories: HDPR36S, -48S/HDER36S, -48S Needed Parts and Tools... -
Page 3: Before You Begin
The wiring diagram is in an envelope attached to the inside of the rangetop. Customer-Assurance Information To resolve questions and installation issues, contact your Dacor dealer or Dacor Customer Assurance. Before calling, have ready the range’s model/serial numbers, which are on the rating label on the back of the range.. -
Page 4: Important Safety Instructions
Important Safety Instructions Safety Symbols and Cautionary Information Electrical and gas equipment can be dangerous if not handled properly. The Important Safety Instructions in this manual are intended to minimize the risk of property damage, personal injury, and death. Carefully follow the instructions in this manual. -
Page 5: Installation-Related Safety Instructions
Important Safety Instructions Installation-Related Safety Instructions • Read these instructions thoroughly to reduce the risk of property damage, fire, personal injury, and death, and to ensure proper installation. • These safety instructions cover installation-related safety issues. For use-and-care-related safety instruc- tions, including general use, electrical, cooktop, and oven safety, see the User Manual. - Page 6 Important Safety Instructions Installation-Related Safety Instructions, cont. Read these instructions thoroughly to reduce the risk of property damage, fire, personal injury, and death, and to ensure proper installation. Gas Safety If you smell gas: • close the range's gas-supply valve and evacuate the building •...
-
Page 7: Consignes De Sécurité Importante
Consignes de sécurité importantes Instructions de sécurité relatives à l'installation • Lisez attentivement ces instructions pour réduire les risques de dommages matériels, d'incendie, de bless- ures corporelles et de mort, et pour assurer une installation correcte. • Ces consignes de sécurité couvrent les problèmes de sécurité liés à l'installation. Pour les consignes de sécurité... - Page 8 Consignes de sécurité importantes Instructions de sécurité relatives à l'installation, suite Lisez attentivement ces instructions pour réduire les risques de dommages matériels, d'incendie, de blessures corporelles et de mort, et pour assurer une installation correcte. Sécurité du gaz Si vous sentez une odeur de gaz: •...
-
Page 9: Product Specifications
Product Specifications HDPR30S, -36S, -48S Ranges HDPR30S HDPR36S HDPR48S English... -
Page 10: Hder30S, -36S, -48S Ranges
Product Specifications HDER30S, -36S, -48S Ranges HDER30S HDER36S HDER48S English... -
Page 11: Included Accessories: Hdpr30S/Hder30S
Product Specifications Included Accessories: HDPR30S/HDER30S *The range comes with brass and porcelain burner caps to suit customer preference. Brass Brass Porcelain Porcelain Grates (2) Standard Burner Caps*: SimmerSear Burner Caps*: Standard Burner Rings (3) Porcelain (3), Brass (3) Porcelain (1), Brass (1) HDPRS HDERS SimmerSear Burner Ring (1),... -
Page 12: Included Accessories: Hdpr36S, -48S/Hder36S, -48S
Product Specifications Included Accessories: HDPR36S, -48S/HDER36S, -48S *The range comes with brass and porcelain burner caps to suit customer preference. Brass Brass Porcelain Porcelain Grates (3) Standard Burner Caps*: SimmerSear Burner Caps*: Standard Burner Rings (4) Porcelain (4), Brass (4) Porcelain (2), Brass (2) SimmerSear Burner Rings (2), GlideRack... -
Page 13: Needed Parts And Tools
Product Specifications Needed Parts and Tools Needed Parts Gas Line Shut-Off Valve Flexible Metal Appliance Flare Union Adapter 3/4” in. Flare Union Adapter 1/2” in. Conduit 1/2-in. (ID) x 5 ft. (NPT) x 1/2 in. (ID) (NPT) x 1/2 in. (ID) 135°... -
Page 14: Installation Requirements
Installation Requirements Pre-Installation Checklist F Before installing the range, read this manual thoroughly. F Plan for a location where the range will not be subject to strong drafts. F Remove packaging, grate boxes, regulator with literature, and literature package from the range, verify that all items are present before beginning the installation. -
Page 15: General Requirements
Installation Requirements General Requirements, cont. Product Dimensions (tolerances: ±1/16” ±1.6 mm) HDPRS/HDERS30: 29 7/8” (75.9 cm); HDPRS/HDERS36: 35 7/8” (91.1 cm); HDPRS/HDERS48: 47 7/8” (121.6 cm) Critical Depth/Height Dimensions HDPRS shown;unique HDERS dimensions indicated* Range-Only Installation Range-With-Downdraft Installation English... - Page 16 5. Does not apply to cabinets that horizontally are over 10” (25.4 cm) from the range edge. Range Downdraft Vent HDPRS/HDERS 30 IMPORTANT: See the downdraft installation instruc- HDPRS/HDERS 36 MRV36-ER tions for duct and electrical installation requirements. HDPRS/HDERS 48 MRV48-ER Use only the specified Dacor downdraft models. English...
-
Page 17: Location Requirements
Installation Requirements Location Requirements Gas/Electrical Range Hookups (HDPRS/HDERS 30”, 36”, 48”) 48” model shown GAS-/ELECTRICAL-ACCESS DIMENSIONS Model HDPR30S/HDER30S 3 ¼" (8.3 cm) 27” (68.6 cm) 6 3/4" (17.1 cm) HDPR36S/HDER36S 6 3/4" (17.1 cm) 27” (68.6 cm) 12” (30.5 cm) 6 3/4 (17.1 cm) 7/8”... -
Page 18: Gas Requirements
Installation Requirements Gas Requirements Provide Adequate Gas Supply • Installation must follow local codes or, in their absence, the National Fuel Gas Code, ANSI Z223.1/NFPA 54. • The cooktop operates at a manifold pressure of 5 in. (13 cm) of water column for natural gas/natural gas at high altitude (NG-H) or 10 in. -
Page 19: Electrical Requirements
Installation Requirements Electrical Requirements Follow these directions to reduce risk of property damage, personal injury, or death. The owner shall ensure that the electrical service meets requirements and that the electrical outlet is properly grounded and installed by a licensed electrician. The correct voltage, frequency, and amperage must be supplied to the range from a separate, grounded, circuit protected by a proper-size circuit breaker or time-delay fuse. -
Page 20: Installation Instructions
Installation Instructions Preparing for Installation • If the gas or electric service provided does not meet the product specifications, discontinue installation, and call the dealer, gas supplier, or a licensed electrician. • Before moving the range into place, install the anti-tip bracket (see below for instructions). Unpacking the Range Unpack the parts box, and verify that all specified components are present (see Pg. - Page 21 Installation Instructions Preparing for Installation, cont. Installing the Anti-tip Bracket and Foot, cont. Floor-Mounting the Anti-tip Bracket, cont. • Determine the anti-tip bracket location (see the diagram below). Mark the 4 hole locations on the floor. • Determine screw size. Minimum full thread depth (portion of screw threaded into the sub-floor) is 3/8” (1 cm) for wood and 5/8”...
- Page 22 Installation Instructions Preparing for Installation, cont. Installing the Anti-tip Bracket and Foot, cont. Wall-Mounting the Anti-tip Bracket For this option to be suitable, the forward edge of the range's front panel must be 26 1/2” (67.3 cm) or less from the wall, and the bracket screws must be able to engage the base plate inside the wall. Notches on the sides of the bracket indicate the minimum height of the base plate and that any floor-covering thick- ness will not impede secure threading.
- Page 23 Installation Instructions Preparing for Installation, cont. Removing the Oven Door So the range is easier to move, remove the door(s) to reduce the weight. • Do not try to disengage the hinge catches with the door(s) removed. The hinge springs could release, caus- ing personal injury.
-
Page 24: Making The Electrical Connection
Making the Electrical Connection • Wire the range according to local ordinances. • Improperly connected electrical wiring can lead to electric shock and appliance damage. Dacor is not re- sponsible for damage due to improper electrical connection. • Connect the ground terminal (or lead) on the range to a grounded, metallic, permanent wiring system or grounding conductor. - Page 25 Installation Instructions Making the Electrical Connection, cont. Connecting the Conduit to the Range For instructions on how to connect the power cord, see Pg. 24. Remove the range's electrical-access cover (see left). 2. (4-wire only) Loosen the grounding screw (E), and re- move the neutral-to-ground jumper link (D).
- Page 26 Installation Instructions Making the Electrical Connection, cont. Connecting the Conduit to the House’s Junction Box Do not connect the range’s green wire to the neutral (white) supply wire unless local code allows. • The power supply must be properly polarized so the burner igniters do not keep sparking after ignition. •...
- Page 27 Installation Instructions Making the Electrical Connection, cont. Connecting a Power Cord to the Range Do not connect the range’s green wire to the neutral (white) supply wire unless local code allows. The range does not come with a power cord; purchase the cord separately. 10-50P 3-Prong Plug (left);...
- Page 28 Installation Instructions Making the Electrical Connection, cont. Connecting a Power Cord to the Range, cont. 5. Insert the end of the cord up through the hole/ strain relief. 6. Attach the power cord’s: a. white (neutral) wire (H) to the neutral termi- nal (B).
-
Page 29: Making The Gas Connection
Installation Instructions Making the Gas Connection • Before connecting the gas line, close the gas shut-off valve, and turn off power to the range at the circuit breaker or fuse box. • Do not apply excessive pressure when tightening gas connections and fittings. •... -
Page 30: Final Installation
Installation Instructions Final Installation Installing the Anti-tip Foot 1. Peel the protective coating from all range surfaces. 2. Measure from floor to countertop. Adjust the leveling legs as needed so the cooktop trim is flush with or above the countertop. 3. - Page 31 Installation Instructions Final Installation, cont. Installing the Burner-Control Knobs Two types of knobs come with the range. The knobs for the center burners (36", 48") and right-side burners (30") feature the words “MAX GRIDDLE,” which refers to the maximum heat setting for a burner over which the griddle is placed.
- Page 32 Installation Instructions Final Installation, cont. Assembling Cooktop Components, cont. Do not operate the cooktop unless all burner components are properly assembled. Installing Standard Burner Components 1. Unpackage the burner components. 2. Install the burner ring so its base fits within the ridge around the burner head, and rotate the ring until it drops into place.
-
Page 33: Verifying Proper Operation
Proper Flame Dacor’s Smart Flame™ feature reduces the flame under the grate fingers to increase grate life. If the range is equipped for LP gas, normal flame tips may be yellow. -
Page 34: Moving The Range For Service
You are ultimately responsible for ensuring that the installation was performed properly by a qualified techni- cian. Dacor is not responsible for property damage or product failure due to improper installation of the range. F Was the plastic coating been peeled off the outside of the range? F Were all packaging materials removed from the oven chamber? F Were the leveling legs lowered to the floor and the unit leveled? (Pg. - Page 35 Notes English...
- Page 36 Dacor – 14425 Clark Avenue, City of Industry, CA 91745 – Phone (800) 793-0093 – Fax (626) 403-3130 – www.dacor.com...
Need help?
Do you have a question about the Heritage Pro HDPR48S and is the answer not in the manual?
Questions and answers