Advertisement
Technical information and requirements
Server power and cooling information
Server dimensions and weight
Server placement requirements
2
EMC SVR-I2U-R2312 Server Installation and Maintenance Guide 0
This section contains the following server information:
Server power and cooling information on page 2
u
Server dimensions and weight on page 2
u
Server placement requirements on page 2
u
Operating limits on page 3
u
Shipping and storage requirements on page 3
u
Table 1 on page 2
contains specifications for the server power consumption and
dissipation. Calculations based on this table are intended to provide maximum power
and heat dissipation. EMC provides a power and weight calculator at
powercalculator.EMC.com. Use this calculator to refine the power and heat values in the
table below to more-closely match the specific server hardware configuration. Ensure that
the server installation site meets the requirements for your configuration.
Table 1 Server power consumption and dissipation
Requirement
-
AC line voltage
Power consumption
(operating maximum)
Heat dissipation
Maximum inrush current
Table 2 Server dimensions and weight
Dimension
Server
-
-
Height
3.34 in (8.76 cm)
Depth
27.75 in (70.48 cm)
Width
17.24 in (43.8 cm) without
cabinet latch brackets
Maximum weight
52 lb (23.6 kg)
There are no restrictions on the location of the server in the cabinet. Allow at least 36
inches of service clearance in front of the cabinet. Power distribution must support the
number of outlets required for the server and the server power rating listed on the Device
Description
-
90-264 V AC, autoranging, 47- 63 Hz
900 VA (883 W) maximum (fully configured)
5
31.80 x 10
J/hr (3015 BTU/hr) maximum
55 A per power supply for 6 ms or less under typical line
conditions and over the entire system ambient operating range
Server with rails
-
2.0 U (with or without bezel)
27.75 in to 29.5 in (70.48 cm to 74.9
cm)
18.99 in (48.24 cm) with cabinet latch
brackets
57 lb (25.9 kg)
http://
Advertisement
