Atag VA6311ST User Manual page 24

24
Using the detergent
A B
30
20
Setting and starting a
programme
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when, af-
ter the activation the display shows 2 hori-
zontal status bars.
If the control panel shows other conditions,
press RESET until the appliance is in set-
ting mode.
Starting a programme without delay
start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Set the programme.
• The related programme number flash-
es in the display.
4. If you want, you can set the options.
5. Close the appliance door. The pro-
gramme starts.
• If you open the door, the display
shows the programme duration that
decreases with steps of 1 minute.
Starting a programme with delay
start
1. Set the programme.
2. Press the delay button again and again
until the display shows the delay time
you want to set (from 1 to 24 hours).
• The delay time flashes in the display.
• The delay indicator is on.
3. Close the appliance door. The count-
down starts.
A
+ -
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
• If you open the door, the display
shows the countdown of the delay
start that decreases with steps of 1
hour.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while the
countdown operates
Press RESET until the display shows 2 hor-
izontal status bars.
When you cancel a delay start, the ap-
pliance goes back to setting mode.
You have to set the programme again.
Cancelling the programme
Press RESET until the display shows 2 hor-
izontal status bars.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed, an in-
termittent acoustic signal operates. The dis-
play shows 0 and the end indicator comes
on.
1. Press the on/off button to deactivate the
appliance.
2. Close the water tap.