Atag VA6311ST User Manual page 22

22
German
degrees
(°dH)
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener
manually and electronically.
Manual adjustment
Electronic adjustment
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'SETTING
AND STARTING A PROGRAMME'.
2. Press and hold buttons (4) and (5) at the
same time until the indicators of buttons
(3), (4) and (5) flash.
3. Press button (3).
• The indicators of buttons (4) and (5)
go off.
Water hardness
French mmol/l
degrees
(°fH)
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7 < 0.7
Clarke
degrees
13 - 17
5 - 12
< 5
Turn the water hardness dial to the position
1 or 2.
• The indicator of button (3) continues
to flash.
• The acoustic signals operate, e.g. five
intermittent acoustic signals = level 5.
• The display shows the setting of the
water softener, e.g.
4. Press button (3) again and again to
change the setting.
5. Deactivate the appliance to confirm the
setting.
Water softener
adjustment
Manual Elec-
tronic
1 3
1 2
2) 2)
1 1
= level 5.