Cleaning And Maintenance - Atag FG6011E Instructions For Use, Installation, And Connection

Cleaning and maintenance

Do not use a steam cleaner or a high-pressure steam cleaner to clean the appliance. Before you
start cleaning the appliance, disconnect it from the power mains and let it cool down.
Appliance housing front
Clean the surfaces with liquid non-abrasive detergents intended for smooth surfaces, and a soft
cloth. Apply the detergent on the cloth and wipe off the dirt; then, rinse with water. Do not apply the
detergent directly on the surfaces. Do not use aggressive or abrasive cleaners, sharp objects or
steel wool, as these will scratch the appliance.
Aluminum surfaces
Aluminum surfaces should be cleaned with non-abrasive liquid detergents intended for such
materials. Apply the detergent on a wet cloth and clean the surface; then, rinse the surface with
water. Do not apply the cleaner directly on the aluminum surface. Do not use abrasive cleaners or
abrasive sponges. The surface should not come into contact with oven cleaning sprays.
Stainless steel front panels (FG6011E)
Clean the surface with a mild cleaner (soapsuds) and a soft sponge that will not scratch the
material. Do not use abrasive or solvent-based cleaners. If these instructions are ignored, the
housing surface can be damaged.
Lacquer-coated and plastic surfaces
Clean the buttons / knobs and the door handle with a soft cloth and liquid detergents intended for
cleaning smooth lacquer-coated surfaces. You may also use the cleaners made especially for this
type of surfaces; in this case, follow the manufacturer's instructions.
WARNING: The above surfaces should never come into contact with oven cleaning sprays, as
these will permanently damage the aluminum parts.
Maintenance
62
Your appliance has been manufactured from high-grade
materials, which are easy for you to clean.
- Burner parts should not be cleaned in the dishwasher.
The parts may be damaged by the dishwasher detergent!
Do not use too much water as this can penetrate into the
burner or ventilation openings.
- Clean the spark plugs preferably with a cloth. Do this carefully.
If too much pressure is applied, the distance from the point of
the sparkplug to the burner may change, causing the burner
to ignite poorly or not at all. The sparkplug will only operate
correctly in a dry environment. If the plug is very dirty, you may
clean the point with a tiny brush.
- Set the pan supports down vertically.
- Assemble the burner parts using the guide ridges