Table of Contents
Advertisement
HMI5000P Installation Guide
Ethernet
If using a switch or router between the PC and the HMI, use a straight-
through or crossover cable as required by the switch or router.
In order to download a project to the HMI over Ethernet, the HMI must be
assigned a unique IP address that is on the same subnet as the
development PC. For more information on Ethernet configuration
options, please refer to the EasyBuilder Pro Programming Manual.
Follow these steps to enter the System Settings menu and assign the
HMI an IP address:
1. Apply power to the HMI.
2. Click the arrow icon located in the lower-right corner of the screen.
3. Click the gear icon to enter the system settings menu.
4. When prompted, enter the system password (default: 111111).
5. Navigate to the Network tab.
6. Enter the desired IP address, or select Obtain an IP Address
Automatically to enable DHCP.
7. Click Apply to save the changes, and OK to exit the system settings
menu.
8. The updated IP address will appear in the system information
window, also accessed via the arrow icon.
1010-1014 Rev 03
www.maplesystems.com
11
Advertisement
Table of Contents
