Table of Contents
Advertisement
Chapter 6
9 Click
Add
to add a controlling rule.
1 )
IP Range:
Enter the IP address. The field can be single IP
address or IP address range according to your demands.
When you configure the single IP address, the computer
with this IP address will get independent given
bandwidth. When you configure the IP address range, all
computers in the range will share the given bandwidth.
2 )
Port Range:
Keep the default settings. The default port
range of TCP protocol or UDP protocol is from 1 to 65535.
3 )
Protocol:
Keep the default setting. Or you can choose the
TCP protocol or UDP protocol or both of them.
4 )
Priority:
Keep the default setting. You can change the
value if you want to first guarantee the bandwidth for
one computer. The smaller value has the higher priority.
5 )
Upstream/Downstream:
to your division.
6 ) Check to enable this entry and click
settings.
10 Repeat Step 6 to add a rule for the other computer. And then
you will get the following table.
Bandwidth Control
Enter the bandwidth according
OK
to save the
40
Advertisement
Table of Contents
