Table of Contents
Advertisement
Available languages
Available languages
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your freezer into its final location, it is important
to make sure you have the proper electrical connection.
Recommended Grounding Method
A 115-volt, 60 Hz., AC-only, 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your freezer be provided. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, press and hold TEMP SETTING for
3 seconds to turn off cooling, and then disconnect the freezer
from the electrical source.
Freezer Door
Tools Needed:
/
" hex-head socket wrench,
5
16
socket wrench, flat 2" putty knife
IMPORTANT:
All graphics referenced in the following instructions are
■
included later in this section after "Final Steps." The graphics
shown are for a right-hand swing door (hinges factory
installed on the right).
If you only want to remove and replace the door, see the
■
"Remove Door and Hinges" and "Replace Door and Hinges."
Before you begin, press and hold TEMP SETTING for 3
■
seconds to turn off cooling, and remove food and adjustable
door or utility bins from door.
Remove Door and Hinges
1. Unplug freezer or disconnect power.
2. Keep the freezer door closed until you are ready to lift it free
from the cabinet.
NOTE: Provide additional support for the door while
the hinges are being moved. Do not depend on the door
magnets to hold the door in place while you are working.
3. Remove the parts for the top hinge as shown in Top Hinge
graphic.
4. Lift the freezer door free from the lower hinge and cabinet and
set aside.
5. Remove the four hex-head hinge screws and bottom hinge
assembly. See "Bottom Hinge" graphic.
Reverse Door (optional on some models)
IMPORTANT: If you want to reverse your door so that it opens in
the opposite direction, continue with "Reverse Door (optional on
some models)" instructions. If you are not reversing the door, see
"Replace Door and Hinges."
4
/
" hex-head
3
8
Hinge screws
Advertisement
Chapters
Table of Contents
