Waring CB15T Manual page 8

Press the green STANDBY button to turn on the
4.
blender. Green LED will illuminate and remain steady.
Select the desired speed with the variable speed
control knob. Press the red START/STOP button to
begin blending. You may change the speed with the
variable speed control knob anytime during blending.
When finished blending, press START/STOP button.
For momentary operation, press the gray PULSE
button; motor will run on HIGH speed until the button
is released. The green LED will blink during operation.
5. Always hold container with one hand when starting
and while blending. Never operate without container
lid properly clamped in place.
6. Allow motor to come to a complete stop before
removing container. Never place the container on the
motor base or remove it from the motor base while
the motor is running.
7. Press the STANDBY button again to turn off the
blender.
8. Remove the container from the motor base and
empty the contents.
9. Wash and dry container after each use. See separate
Cleaning & Sanitizing Instructions for All Waring
Blenders.
Not for water-jet cleaning.
10.
11. The use of ear protection is recommended during
extended operating periods.
TO REALIZE MAXIMUM SERVICE LIFE, OBSERVE THE
FOLLOWING PRECAUTIONS:
1. Do not lubricate container bearing, drive shaft,
or shaft seals. These parts are lubricated and
sealed at the factory and do not require any further
lubrication.
8