Preparation - Chamberlain C2405C Istallation Manual

Preparation

Preparation
Check the Door
To prevent possible SERIOUS INJURY or DEATH:
ALWAYS call a trained door systems technician if garage door binds, sticks, or is out of

balance. An unbalanced garage door may NOT reverse when required.
NEVER try to loosen, move or adjust garage door, door springs, cables, pulleys, brackets

or their hardware, ALL of which areunder EXTREME tension.
Disable ALL locks and remove ALL ropes connected to garage door BEFORE installation

and operating garage door opener to avoid entanglement.
DO NOT install on a one-piece door if using devices or features providing unattended close.

Unattended devices and features are to be used ONLY with sectional doors.
To prevent damage to garage door and opener:
ALWAYS disable locks BEFOR Einstalling and operating the opener.

ONLY operate garage door opener at 120V, 60 Hz to avoid malfunction and damage.

Before you begin:
1. Disable locks and remove any ropes connected to the garage door.
2. Lift the door half way up. Release the door. If balanced, it should stay in place, supported
entirely by its springs.
3. Raiseand lower the door to checkfor binding or sticking. If your door binds, sticks, or is out
of balance, call atrained door systems technician.
4. Checktheseal on thebottomof thedoor. Any gap between thefloor and the bottom of
thedoor must not exceed 1/4" (6 mm). Otherwise, the safety reversal system may not
workproperly.
5. Theopener should be installed above the center of thedoor. If thereis atorsion spring
or center bearing platein theway of the header bracket, it may beinstalled within 4 feet
(1.2 m) totheleft or right of thedoor center. See page 13.
Torsion
Spring Extension
Spring
Before You Connect with Your Smartphone
Monitor and control your garage door from anywhere using the myQ
a router with Wi-Fi ® and a smartphone or other mobile device. Make sure your mobile
device is connected to your Wi-Fi
®
your garage door opener will be installed and check the Wi-Fi
signal strength.
Check Signal Strength. If you see:
Visit support.chamberlaingroup.com for more details.
See myQ App Control page 37 to connect your garage door
®
opener to your Wi-F i® network.
3
App. You will need
®
network. Hold your mobile device in the place where
®
Wi-Fi signal is strong. You're all set!
Install your new garage door opener.
Wi-Fi signal is weak.
The garage door opener will likely connect to your Wi-Fi
network. If not, try one of the options below.
No Wi-Fi signal. Try one of the following:
• Move your router closer to the garage door opener
to minimize interference from walls and other objects
• Buy a Wi-Fi range extender