Configuring The Access Point; Step 1: Login - Pakedge WX-1-O Quick Start Manual

Hide thumbs Also See for WX-1-O:

Configuring the Access Point

There are multiple ways to log in to the WX-1-O. Please see 2 options below:

Option 1: Using Ethernet cable

Connect a computer to the WX-1-O through an Ethernet cable. Enter 192.168.1.250 into the

address bar of your web browser. You should see a login page. In the username box, type pakedge.

In the password box, type pakedgea and click Login.

NOTE:

If your computer is not set to the default IP scheme of the WX-1-O (192.168.1.X), you must

first configure the TCP/IP settings on your computer to log in to the WX-1-O through a web

browser.

Using Windows 7

Under Control Panel – Network and

Internet, click on View Network Status

and Tasks.

On the left panel, click on Change

Adapter Settings and right-click Local

Area Connection. Select Properties.

Select Internet Protocol Version 4

(TCP/IPv4) and click Properties.

Select Use The Following IP Address

and enter the following information:

IP Address: 192.168.1.10

Subnet Mask: 255.255.255.0

Additional settings can be left blank.

Click "OK" and "Close"

Following page will display when logged in:

Table of Contents