Table of Contents
Advertisement
Installation
Electrical connection
Connecting appropriate power supply ` terminal board/ connector block:
•Using a screwdriver ,prize open tabs of the Terminal board cover.
•Remove the wire clamp screw.
•Fasten the wires beneath the corresponding screw heads, using
brass 'bridge' for single phase supply.
•Fasten cable clamp and close the cover of the terminal board.
•The ac power supply should be 230V - 50Hz. Cooker is rated at
7150W connected load. For electric cookers,the minimum 32A circuit
breaker. When connecting to multiphase 230/240V supply, remove
the relevant bridge pieces between ACTIVE connections.
NOTE: To be carried out by a qualified electrician / installer.
Connect the cable directly to the mains, connection to the
electricity supply must be made by an authorised person in
accordance with the Wiring Rules AS/NZS3000. The installation
must include a suitable isolating switch with a minimum contact
opening of 3mm between the appliance and the mains. The
isolating switch should be sized according to the load on the data
label and should comply with current regulations (the earth wire
should not be interrupted by the circuit breaker).
Before making the connection check that:
・ the switch, wiring and electrical system can support the
appliance load (see data plate);
・ the power supply system has an efficient earthing connection
which complies with the provisions of current regulations;
・ the power outlet or omnipoar circuit-breaker is easily accessible
once the cooker has been installed.
Replacing the power supply lead
If the supply cord or plug is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid hazard.
Before leaving
When the installation is complete, operate each element and the
oven to check that they are operating correctly. Make sure the
indicator lights are also operating correctly.
When satisfied with the operation, please instruct the user on the
correct method of operation. In case the appliance fails to operate
correctly after all checks have been carried out, please call the
Technika Service Centre.
31
Advertisement
Table of Contents
