Spektrum SPMAR8360T Manual page 22

EN
Problem
Aircraft will not
connect (after
binding) to
transmitter
Control surface
does not move
22
Possible Cause
Transmitter too near
aircraft during connecting
process
Aircraft or transmitter is
too close to large metal
object, wireless source or
another transmitter
Bind plug left installed in
bind port
Aircraft bound to different
model memory.
Flight battery/Transmitter
battery charge is too low
Transmitter may have
been bound to a different
aircraft using different
DSM protocol
Control surface, control
horn, linkage or servo
damage
Wire damaged or
connections loose
Transmitter is not bound
correctly or the incorrect
model was selected
Flight battery charge
is low
BEC (Battery Elimination
Circuit) of the ESC is
damaged
Solution
Move powered transmitter a few
feet from aircraft, disconnect
and reconnect flight battery to
aircraft
Move aircraft and transmitter
to another location and attempt
connecting again
Rebind transmitter to the aircraft
and remove the bind plug
before cycling power
Select correct model memory
on transmitter
Replace/recharge batteries
Rebind aircraft to transmitter
Replace or repair damaged
parts and adjust controls
Perform a check of wires and
connections, connect or replace
as needed
Rebind or select correct
airplanes in transmitter
Fully recharge flight battery
Replace ESC