Assembly Steps - Tradecraft Specialties SURFBUS-1 Instruction Manual

Bed frame for twin mattress

Assembly Steps

Step 1: Ensure there is enough room to lay out all parts. Carefully unpack all parts and hardware

and check that everything is present and undamaged. It is helpful to have more than one person

available for assembly.

Step 2: Loosely fasten side assemblies [A] to headboard [D] using lag bolts [E] and flat washers [F],

(2) lag bolt per side with a washer on each lag bolt. Do not yet fully tighten hardware.

Step 3: Fasten mattress support bars [B] to support rail of side assemblies [A] using screws [C]. Use

(1) screw at each end of support bar. Make sure support bar end is tight and perpendicular with side

of bed. Start at rear of bed and work towards front. Leave 4.5" gaps between each support bar

(approximately 7" center-to-center).

Page

Model SURFBUS-1 Surfer Bus Bed Frame

Revised 10/18/2017

5 of 6

Table of Contents