Advertisement
Instruction Manual
Bed Frame For Full Mattress
Model SPSHTL-4
Due to the presence of small parts during assembly, keep
out of reach of children until assembly is complete.
Model SPSHTL-4 Space Shuttle Bed Frame
Read all instructions before assembly and use.
Keep instructions for future use.
ADULT ASSEMBLY REQUIRED
Lancaster, PA 17601
tradecraftspecialties@gmail.com
www.tradecraftspecialties.com
Revised 05/06/2016
1900 Alfa Drive
(717) 269-8934
Page
1 of 8
Advertisement
Table of Contents
Related Manuals for Tradecraft Specialties SPSHTL-4
Summary of Contents for Tradecraft Specialties SPSHTL-4
- Page 1 Due to the presence of small parts during assembly, keep out of reach of children until assembly is complete. 1900 Alfa Drive Lancaster, PA 17601 (717) 269-8934 tradecraftspecialties@gmail.com www.tradecraftspecialties.com Page Model SPSHTL-4 Space Shuttle Bed Frame Revised 05/06/2016 1 of 8...
- Page 2 Please verify that you or your child does not have an allergy to linseed oil before using this product. General Specifications Assembled dimensions (approximate): 92" long, wide, 39" high. Page Model SPSHTL-4 Space Shuttle Bed Frame Revised 05/06/2016 2 of 8...
- Page 3 We use low-odor, zero VOC paint where possible and do our best to keep unpleasant odors to a minium. Disassembly To disassemble, reverse order of steps for assembly. Page Model SPSHTL-4 Space Shuttle Bed Frame Revised 05/06/2016 3 of 8...
- Page 4 Parts List Page Model SPSHTL-4 Space Shuttle Bed Frame Revised 05/06/2016 4 of 8...
- Page 5 Step 2 - A: Loosely fasten side assemblies [A] to rear shelf support [G] using lag bolts [E] and flat washers [F], (1) lag bolt per side with a washer on each lag bolt. Do not yet fully tighten lag bolts. Page Model SPSHTL-4 Space Shuttle Bed Frame Revised 05/06/2016 5 of 8...
- Page 6 Step 2 - B: Fasten shelf [H] to headboard [D] and shelf rear support [G] with screws [I]. Page Model SPSHTL-4 Space Shuttle Bed Frame Revised 05/06/2016 6 of 8...
- Page 7 (1) screw at each end of support bar. Make sure support bar end is tight and perpendicular with side of bed. Start at rear of bed and work towards front. Leave 4.5” gaps between each support bar (approximately 7” center-to-center). Page Model SPSHTL-4 Space Shuttle Bed Frame Revised 05/06/2016 7 of 8...
- Page 8 Step 4: Tighten all hardware. Make sure all assembled parts are tight and secure. Page Model SPSHTL-4 Space Shuttle Bed Frame Revised 05/06/2016 8 of 8...
Need help?
Do you have a question about the SPSHTL-4 and is the answer not in the manual?
Questions and answers