Tradecraft Specialties SURFER-1 Instruction Manual

Bed frame for full mattress

Instruction Manual

Bed Frame For Full Mattress

Model SURFER-1

Due to the presence of small parts during assembly, keep

out of reach of children until assembly is complete.

Model SURFER-1 Surfer Bed Frame

Read all instructions before assembly and use.

Keep instructions for future use.

ADULT ASSEMBLY REQUIRED

Lancaster, PA 17601

tradecraftspecialties@gmail.com

www.tradecraftspecialties.com

Revised 04/11/2016

1900 Alfa Drive

(717) 269-8934

Page

1 of 6

Table of Contents

Need help?

Do you have a question about the SURFER-1 and is the answer not in the manual?

Page 1 Due to the presence of small parts during assembly, keep out of reach of children until assembly is complete. 1900 Alfa Drive Lancaster, PA 17601 (717) 269-8934 tradecraftspecialties@gmail.com www.tradecraftspecialties.com Page Model SURFER-1 Surfer Bed Frame Revised 04/11/2016 1 of 6...
Page 2 Please verify that you or your child does not have an allergy to linseed oil before using this product. General Specifications Assembled dimensions (approximate): 89" long, 54.5" wide, 24" high. Page Model SURFER-1 Surfer Bed Frame Revised 04/11/2016 2 of 6...
Page 3 The smell should completely dissipate within several days. The smell may be stronger on products with areas of exposed unpainted material. Disassembly To disassemble, reverse order of steps for assembly. Page Model SURFER-1 Surfer Bed Frame Revised 04/11/2016 3 of 6...
Page 4 Parts List Page Model SURFER-1 Surfer Bed Frame Revised 04/11/2016 4 of 6...
Page 5 Step 2 - A: Loosely fasten side assemblies [A] to rear shelf support [G] using lag bolts [E] and flat washers [F], (1) lag bolt per side with a washer on each lag bolt. Do not yet fully tighten lag bolts. Page Model SURFER-1 Surfer Bed Frame Revised 04/11/2016 5 of 6...
Page 6 Start at rear of bed and work towards front. Leave 4.5” gaps between each support bar (approximately 7” center-to-center). Step 4: Tighten all hardware. Make sure all assembled parts are tight and secure. Page Model SURFER-1 Surfer Bed Frame Revised 04/11/2016 6 of 6...