Tradecraft Specialties SWXWNG-1 Instruction Manual

Bed frame for twin mattress

Instruction Manual

Bed Frame For Twin Mattress

Model SWXWNG-1

Due to the presence of small parts during assembly, keep

out of reach of children until assembly is complete.

Model SWXWNG-1 X-wing Fighter Bed Frame Revised 04/05/2015

Read all instructions before assembly and use.

Keep instructions for future use.

ADULT ASSEMBLY REQUIRED

Lancaster, PA 17601

tradecraftspecialties@gmail.com

www.tradecraftspecialties.com

1900 Alfa Drive

(717) 269-8934

Page

1 of 6

Table of Contents

Need help?

Do you have a question about the SWXWNG-1 and is the answer not in the manual?

Page 1 Due to the presence of small parts during assembly, keep out of reach of children until assembly is complete. 1900 Alfa Drive Lancaster, PA 17601 (717) 269-8934 tradecraftspecialties@gmail.com www.tradecraftspecialties.com Page Model SWXWNG-1 X-wing Fighter Bed Frame Revised 04/05/2015 1 of 6...
Page 2 Excess space may result in entrapment which may lead to serious injury or death. General Specifications Assembled dimensions (approximate): 89" long, 39.5" wide, 24" high. Page Model SWXWNG-1 X-wing Fighter Bed Frame Revised 04/05/2015 2 of 6...
Page 3 Disassembly To disassemble, reverse order of steps for assembly. Page Model SWXWNG-1 X-wing Fighter Bed Frame Revised 04/05/2015 3 of 6...
Page 4 Parts List Page Model SWXWNG-1 X-wing Fighter Bed Frame Revised 04/05/2015 4 of 6...
Page 5 Step 2 - A: Loosely fasten side assemblies [A] to rear shelf support [G] using lag bolts [E] and flat washers [F], (1) lag bolt per side with a washer on each lag bolt. Do not yet fully tighten lag bolts. Page Model SWXWNG-1 X-wing Fighter Bed Frame Revised 04/05/2015 5 of 6...
Page 6 Start at rear of bed and work towards front. Leave 4.5” gaps between each support bar (approximately 7” center-to-center). Step 4: Tighten all hardware. Make sure all assembled parts are tight and secure. Page Model SWXWNG-1 X-wing Fighter Bed Frame Revised 04/05/2015 6 of 6...