Assembly Steps - Tradecraft Specialties SEMITR-25 Instruction Manual

Bed frame for twin mattress

Assembly Steps

Step 1: Ensure there is enough room to lay out all parts. Carefully unpack all parts and hardware

and check that everything is present and undamaged. It is helpful to have more than one person

available for assembly.

Step 2: Loosely fasten side assemblies [A] to headboard [D] using lag bolts [E] and flat washers [F],

(2) lag bolt per side with a washer on each lag bolt. Do not yet fully tighten hardware.

Step 3: Fasten mattress support bars [B] to support rail of side assemblies [A] using screws [C]. Use

(1) screw at each end of support bar. Support bar end shall be perpendicular with side of bed. There

may be a slight gap between end of support bar and side of bed. Start at rear of bed and work

towards front. Leave approximately 4.5" gaps between each support bar (approximately 7" center-to-

center).

Model SEMITR-25 Semi Truck Bed Frame

Revised 12/05/2018

Page

5 of 6

Table of Contents