Ip Filter - D-Link 8DLDCS936L User Manual

Section 3 - Configuration
The IP Filter is a feature used to allow or deny certain IP addresses when accessing the DCS-936L. Please note that when creating an allow list, if the
IP address of your computer is not included or if you do not set up an administrator IP address, you may be locked out of accessing your camera. In
this event, you will need to do a hard reset of your camera by pressing the reset button for more than 10 seconds while it is powered on.
Access List
Check this box to enable the IP Filter function.
Filtering:
Filter Type: Select whether to set the filter to allow or to deny connection from the IP
addresses listed.
IPv4 Filter List:
The current list of IPv4 addresses that are being filtered. Select a line and
the click the delete button to remove that entry.
IPv6 Filter List: The current list of IPv6 addresses that are being filtered. Select a line and
the click the delete button to remove that entry.
Add New Filter. From the drop down menu, select whether to add a single IP, an entire
subnet, or a range of IP addresses. Enter an IP address, subnet, or IP range,
then click Add to create a new filter.
Administrator You can allow a single IP address to always have access to this camera,
IP Address. regardless of the IP filter rules being used, by enabling this option and
entering the IP address.
Click Save Settings to save your changes.
D-Link DCS-936L User Manual

IP Filter

41