NOT intended to replace proper supervision of children. D-Link and the D-Link logo are trademarks or registered trademarks of D-Link Corporation or its subsidiaries in the United States or other countries. All other company or product names mentioned herein are trademarks or registered trademarks of their respective companies.
Package Contents DCS-820L Wi-Fi Baby Camera Wall Mount Kit Power Adapter Blue Accent Ring Quick Install Guide If any of the above items are missing, please contact your reseller. Minimum Requirements • Smartphone or tablet: Refer to the mydlink Baby App page on the App Store and Google Play • Computer with: • 1.3GHz processor or above and at least 128 MB RAM • Microsoft Windows® 8, 7, Vista® or XP, Mac OS® X (10.6 or higher) • Internet Explorer® 7, Firefox® 12, Safari® 6, or Chrome™ 20 or higher with Java installed and enabled • Internet access required for remote viewing • 802.11g/n Wi-Fi® network (Wireless N network recommended for optimal performance)
Hardware Overview Front View Night Vision (IR) LEDs Focus Ring Camera Lens Light Sensor Microphone Front Accent Ring Camera Base Back View Bottom View Direct Connect Button Reset Button Speaker microSD Slot Micro USB Power Port Power LED Cloud LED...
Installation WARNING - STRANGULATION HAZARD Children have STRANGLED in cords. Keep adapter cord out of reach of children (minimum of 3 ft or 1m away). NEVER place the camera or adapter cord inside the crib or child sleeping area. Do not use extension cords.
Tap Setup on the start screen to launch the Setup Wizard. It will guide you through the configuration process.
Mount the Camera Please refer to the steps below to assist you with mounting the camera. We suggest that you configure the camera before mounting. Warning: Indoor use only. Do not mount in a location where it may be in contact with water as it may damage the product and/or cause injury. Use a 6mm drill bit to drill two holes 43mm apart, and at least 30mm deep. Then use a mallet 30mm o insert the wall anchors into the holes. 43mm crew the included screws into the wall anchors. Place the mounting holes on the base of the camera over the screws as shown, then slide the DCS-82 0L FCC ID: KA2CS825...
FAQs 1. The Image is out of focus. You can turn the white focus ring on the front of the camera to adjust the focus. 2. How do I change the accent rings? Rotate the accent ring counterclockwise, then lift it off. Put the new ring on and rotate it clockwise until it clicks into place. I started the mydlink Baby Camera Monitor app, but I can’t find my camera. • Make sure your camera is turned on and receiving power. • If you are setting up a new camera, make sure your smartphone or tablet is connected to the camera’s Wi-Fi signal (not your wireless router). • The Wi-Fi network name should be [myBabyCam-XXXX], where XXXX is a 4-digit code (the last four digits of your camera’s MAC address).
7. Should the app be running constantly on my device? The app can run in the background, allowing you to hear your baby continuously, even when the phone is locked. The smartphone or tablet can still be used normally while the app is running. If you do not want to hear audio from the camera when the app is open, you can turn off the Background audio on the Configuration menu. If you close the app, the camera audio will be turned off. 8. How do I adjust the noise and motion responsiveness? From the Live View page, tap on the screen to reveal the icons, and tap the Configuration icon ( ) to go to Configuration menu. Tap the Events arrow to access the motion and audio detection settings.
(USA) or http://support.dlink.ca (Canada) for more information. Also feel free to contact us through our website. http://support.dlink.com Canada http://support.dlink.ca Camera Wi-Fi Network Details: Your Camera Password: Version 1.00(US) 6CS820LNAQ01G February 18, 2014 Copyright 2014 All rights reserved. D-Link and the D-Link logo are registered trademarks of D-Link Corporation or its subsidiaries. Other trademarks are the property of their respective owners. Maximum wireless signal rate derived from IEEE Standard 802.11g and 802.11n specifications. Actual data throughput will vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead, lower actual data throughput rate. Environmental factors will adversely affect wireless signal range. Product specifications, size and shape are subject to change without notice, and actual product appearance may differ from that depicted on the packaging. Visit dlink.com (US) or dlink.ca (Canada) for more details.